в том случае у меня, когда до установки клиента не был полностью настроен IP (адреса, DNS) и т.д. помогал полный снос NW32, TCP/IP, установка протокола снова, настройка, а уже потом NW32.
Но вы говорите, что настройки протокола уже есть, я не смог найти у себя этой статьи, но в этом случае после установки клиента необходимо запустить, какой то exe-шник из дистрибутива клиента, только не помню какой
то ли ws2nsins, то ли ws2setup. Мне это помогало. что то связано с winsock2 в клиенте, по моему. Вот еще из ФАКов, может поможет:
Question #001
After installing any 3.x client, I have have had problems with either IP or Internet connectivity. What could cause this problem.
Solution
The Novell Client 3.x and higher will automatically apply the Microsoft Winsock2 upgrade to the PC during the client install. The following steps will help you backup off the Winsock2 upgrade to the original Winsock1.1. During the upgrade, the old Winsock files are saved and a batch file is created to perform the downgrade process.
1)Run C:\WINDOWS\WSBAKUP.BAT
2)Restart Windows with the – "Command Prompt only option"
3)Again run C:\WINDOWS\WSBAKUP.BAT
4)Restart PC Normally
The reason this must be run twice is that the batch files both makes registry entries and restores old files.
The registry entry updates require windows for the updates to occur. The files, however, cannot be restored due to file locking while windows is running. Thus the first run will correct the registry while the second backdates the files.
Question #002
How do I prevent the Winsock 2.0 upgrade from occurring during the install of client 3.x?
Solution
Edit the NWSETUP.INI from the Novell Client installation source directory.
Comment out the "2=WS2SETUP.EXE, <, 1998" line in the [Client.Run] section. This section should look like the following after commenting out this line:
[Client.Run]
1=WS2NSINS.EXE /install,>=1998
;2=WS2SETUP.EXE,<,1998
3=AXDIST.EXE,<,1111
Question #003
Why does Novell include the Winsock 2.0 upgrade in it’s client package.
Answer
Winsock 2.0 is required for SLP (Service Location Protocol) and the IP Gateway. If you do not need these services, then do not need to do the Winsock 2.0 upgrade.
Question #004
I believe that I need the Winsock upgrade, but it causes problems on my machines. What should I do?
Answer
The Winsock 2.0 upgrade seems to work better if it is installed prior to the client 3.x upgrade. Try pushing the WS2SETUP.EXE prior to the deployment of the 3.x client. The upgrade could also be pushed via a snapshot.