Черников Виктор » 15 фев 2005, 13:45
#---------------------------------------------------------------------------
# Backup Exec SureStart
#
# GSI1\SYS:\BKUPEXEC\BKUPEXEC.FAX
#
# Tue Feb 15 12:41:20 2005
#---------------------------------------------------------------------------
Beginning the initialization procedure
Current system parameters are as follows
LoadType: Not specified
API mode: Directory Services
Driver: Not specified
DMA mode: Use memory below 16 megabyte boundary
Driver mode: Asynchronous
ASPI Manager: Using NWAPI.CDM
Driver bus mode: Physical Bus
Autoload Novell TSAs: 1
Validate NLM Versions: 1
Validate memory: 1
Debug: On: 0 ZL: 0
Internal: RA: 0 RQ: 0 MC: 0 UB: 0 LE: 0
Initializing internal control parameters
Initializing secondary control parameters
Initializing system operating paths
Initializing NOS Links
Initializing Load Subsystem
Initialization complete
Validating system environment
Validating system memory resources
Cache boundaries are 65%High - 40%Medium - 20%Low
44% of the cache buffers on the server are currently available.
---------------------------------------------------------------------------
Note: 1008
44% of the cache buffers on the server are currently available.
Novell recommends 65% for optimum server performance
---------------------------------------------------------------------------
System environment validation has completed
No updates needed.
Loading dependent modules
Module SPXS.NLM is already loaded
Module TLI.NLM is already loaded
Module DSAPI.NLM is already loaded
Module SMDR.NLM is already loaded
Loading module TSA500.NLM
Loading module TSANDS.NLM
Module NWPA.NLM is already loaded
Module NWIDK.NLM is already loaded
Loading module OTMCDM.CDM
1 returned while attempting to load OTMCDM.CDM
---------------------------------------------------------------------------
Error: 1006
Unable to load required module OTMCDM.CDM
Refer to the troubleshooting section of the Administrator's Manual
for additional information on this error.
---------------------------------------------------------------------------
Press <Alt+Esc> to return to the Server Console. After you resolve
the error condition(s), re-execute the BESTART command.