Андрей Троценко » 09 июл 2003, 11:33
Мой NET.CFG ничем не примечателен, он ниже. Кстати, проверил, без параметров SLOT, с разными сетевыми - тоже работает без вопросов. SLOT нужен когда у вас несколько карточек одной модели, либо драйвер не уверен в выборе.
Если нужно срочно запустить, Владимир Горяев прав - можете сделать нечто вроде "echo 2 | PCIODI" - должно сработать за ввод с клавиатуры.
А все поддерживаемые конкретной платой параметры, можно (обычно) найти в файле NET.CFG, что на дискете с драйверами к плате, в директории NWCLIENT (или аналогичной).
NET.CFG Begin
NETWARE DOS REQUESTER
Auto Reconnect = ON
Auto Retry = 10
Confirm Critical Error = ON
Show Dots = ON
Message Level = 1
Message Timeout = 60
NetWare Protocol = NDS
; Use Defaults = ON
First Network Drive = I
Preferred Tree = UOSK
; Name Context = "OU=Services.O=USICo"
Link driver NE2000
INT 5
PORT 320
Link Driver EP320XR
; BUSNO NN ; where NN is the PCI bus identifier of the PCI bus which connects to the adapter.
; DEVICENO NN ; where NN is the specific PCI BIOS device identification number of the specified PCI adapter.
; ETHERID 00002100000A ;use ETHERID to designate adapter by its Node Address
; FRAME Ethernet_802.2 ; specify frame type
; MEDIUM AUTO|10HALF|10FULL|100HALF|100FULL
Link Driver FEAODI
; FullDuplex disable ;auto/disable/enable(auto)
; PortSpeed 100M ;auto/10M/100M(auto)
Link Driver RE100ATX
; BUSNO NN ; where NN is the PCI bus identifier of the PCI bus which connects to the adapter.
; DEVICENO NN ; where NN is the specific PCI BIOS device identification number of the specified PCI adapter.
; ETHERID <node addr> ; you can use ETHERID to designate adapter by its Node Address e.g. ETHERID 008048xxxxxx
; FRAME Ethernet_802.2
; MEDIUM AUTO
NET.CFG End