Страница 1 из 1

SP7 и BM3.6

СообщениеДобавлено: 28 июн 2004, 16:27
Sergey Tarabrin
..на NW5.1sp6+BM36sp2a установил SP7, после этого transparent telnet proxy перестал мониторить все настроенные порты: 25, 110 и 443.
Ничего умного пока не придумал...
Любые идеи.

P.S.: http://nscsysop.hypermart.net/bmgrptch.html#BM36 не помог

Re: SP7 и BM3.6

СообщениеДобавлено: 30 июн 2004, 10:36
Владимир Горяев
Sergey Tarabrin писал(а):P.S.: http://nscsysop.hypermart.net/bmgrptch.html#BM36 не помог
Reinstall this patch even if it was previously installed due to the older NIAS files being installed by BorderManager 3.6. See the note above about the installation of older files problem. TCPIP modules are also affected. Replaces NW51SP6, PURGE_NW.EXE, NW56UP3.EXE, and NLS603FT.EXE. Note: After installing this patch, you may have to remove a space after any ? commands in your autoexec.ncf. See tip #19.
Любые идеи.
Патчи нужно ставить именно в том порядке как указано там. Т.е. придется переустановить BM36SP2A. Была подобная проблема с BM35, помогло именно переустановка патчей.